ilmixmoto

Hi all!

after a long and sweaty job to unsolder the eprom from the ecu (not trying to unsolder) I managed to read the file ori for this ecu.

Now I would like to be able to proceed with the remapping, but my problem is that ecm titanium does not find any drivers and therefore I do not know where to put the hands.

the remapping you want to do is very minimal.. I would like to first of all remove the cut off at the time of release to get the bangs in the release and maybe something more, improving the provision and give it more boost over 5000 rpm, where it is sitting..

I would appreciate very much a help from all of you!

thanks

Errecinque

Hi all!

after a long and sweaty job to unsolder the eprom from the ecu (not trying to unsolder) I managed to read the file ori for this ecu.

Now I would like to be able to proceed with the remapping, but my problem is that ecm titanium does not find any drivers and therefore I do not know where to put the hands.

the remapping you want to do is very minimal.. I would like to first of all remove the cut off at the time of release to get the bangs in the release and maybe something more, improving the provision and give it more boost over 5000 rpm, where it is sitting..

I would appreciate very much a help from all of you!

thanks
I believe that a car of this kind is little known and difficult to find info if you don't find the damos accurate to the ecu.

ilmixmoto

I believe that a car of this kind is little known and difficult to find info if you don't find the damos accurate to the ecu.

thanks

I hope the same that maybe qualqunaltro have the driver or damos needed...
crossing my fingers!

ilmixmoto

anyone that can give me a helping hand?