thekid

Hi to all I tried to read this ecu (8n0906018bh 0261207751) with galletto or mpps and galletto returns error sk1 error seed key in the data read already while mpps is the ecu id but 70% of the reading error.

Does anyone know if there are tricks to read this ecu. THE voltage was above 13v for reading

cinqueturbo

Hi to all I tried to read this ecu (8n0906018bh 0261207751) with galletto or mpps and galletto returns error sk1 error seed key in the data read already while mpps is the ecu id but 70% of the reading error.

Does anyone know if there are tricks to read this ecu. THE voltage was above 13v for reading

The trick would be to read it on the bench in boot mode if a BOSCH ME7.5.5

but the 2002 model you had to read to the bench with a programmer desolder PLCC as the edc15p

rego88

in fact, it depends on the ecu mounts, attention, I wish it was an old version of the nn-readable serial?? I understand' to me, and I had to unsolder the 29f on the golf 4 ;)

thekid

I had read something about a fuse to be removed if the read was not successful

cinqueturbo

Test...
Fuse 11 in the dash if I'm not mistaken..

guidotacco

05-03-2016, 15:18

boot mode the read

munro

however, I believe that there is no need to unsolder anything if you put in the boot...
the kid's no way to do a total backup? help me to study...
I'm trying to activate the antilag and the bang via micro....

munro

I wanted to say the launch boost and antilag or bang bang via the microprocessor..