overbooster

hi guys give me a hand to close the egr?

cinqueturbo

I don't have any news on this.. I think you should simply remove the plug and DTC

overbooster

ok thanks a lot

Errecinque

I don't have any news on this.. I think you should simply remove the plug and DTC
I read very often that it is easier to remove the dtc on the siemens trovarebi controls. But there is a rule like that of the edc16 to find a "hand " without the sw the dtc on these ecu's?

sportknight

looking for the error code you find that it curves at the beginning of the map(usually),the cudice is in a curvetta low,then starts a curve, the most high,by lowering the peak clear the dtc,test with dtc remover on a siemens so you realize,then it will be easier to do so on the other

overbooster

P0409 - P0487 plug detached. I tried looking for them, but you repeat too many times seem all the same

legendaryslave

vc power proposes a solution I never tested it to try

cinqueturbo

Also the team professionalchiptuning has the solution..

sisco

looking for the error code you find that it curves at the beginning of the map(usually),the cudice is in a curvetta low,then starts a curve, the most high,by lowering the peak clear the dtc,test with dtc remover on a siemens so you realize,then it will be easier to do so on the other

Hello sportknight, I'm also following I this post and looking at the file I found 4 0409, 2 of these seem to be interesting exactly to the addresses 0413E0 and 0413EA, 0407 I found 10 0415E0-0415EA-041600-04160A and so on until the tenth (close by), can you say specifically how you should proceed to clear (if you go of course)

andrea80

This you do by removing the plug of the egr. Then turn on the error and read a diagnosis on what is.... With dtc remover the remove quietly.