alegsxr

Hello all,

I am writing a lot but write very little :( and I'm sorry.

I have a problem with a scania 164 580cv. In practice, the half smoke a lot.

I would like to compare my map to that of a 480 but the various ori that I find around and I can't open them. Bha...

Anyone got an ORI of 480 (model with MS6.2) and a 580 (same ECU)?

Thanks,
Alessio

alegsxr

Anyone help me know?

sisco

Hello all,

I am writing a lot but write very little :( and I'm sorry.

I have a problem with a scania 164 580cv. In practice, the half smoke a lot.

I would like to compare my map to that of a 480 but the various ori that I find around and I can't open them. Bha...

Anyone got an ORI of 480 (model with MS6.2) and a 580 (same ECU)?

Thanks,
Alessio

but I think that you can not download it with the messages that you have, if the admin gives you permission to post a ***** I send it to you, (but only if we authorize, because I don't want to go against the rules)

alegsxr

but I think that you can not download it with the messages that you have, if the admin gives you permission to post a ***** I send it to you, (but only if we authorize, because I don't want to go against the rules)

Thanks Sisco I understand,

I look forward to an admin then...pleassseee...:)

alegsxr

Of course, if for a response from an admin you have to wait so much is not that this forum is so guarded.

sisco

Hi Alex, do one thing mail your file that you tell if it is ori or not, then I ask you for the truck pulls? or does it only smoke, but not go, if not, go and smoke, try to seal intercooler because they break quite often, and also see the piece of aluminum in the middle of the v of the cylinder, it breaks down in the vicinity of the screws of the bracket that supports the aluminum tube that goes from the turbo to the intercooler, remove the sensor from the turbo and from a clean, (it's located on the intake manifold group dx)
do you know, hello Sisco