Pasticciona0

Hello everyone, I would like to take this opportunity to make my wishes for happy holidays...I hope you all had a merry Christmas.
Therefore, today up for lost time I tried to read the ECU of one of the machines of the family (as the title). I use a galletto v54: in the reading it tells me that I have to put it in boot mode....I stop, go home, study and she informed me about everything and I understand what I need to do....the only question that is left to me is:

p.s. but the body of the ECU that you know is always linked to a mass or is it better that the texts first?

Pasticciona0

There is no one that can give me some elucidation about this ECU?!?

munro

connect the cock in the serial is try to read it nothing happens if you mess up something if you can't read from serial port you have to force it in boot them up, then follow the instructions of the fg tech to be quiet....

Pasticciona0

connect the cock in the serial is try to read it nothing happens if you mess up something if you can't read from serial port you have to force it in boot them up, then follow the instructions of the fg tech to be quiet....

Ok, I'll try...I tried to look in the folder of FG tech to boot to this device but I have not found the PDF...I found all the info by turning and stirring on the internet.....

ugoboss

I have never been able to make them without the boot, in any case, try and limit the uses of this pattern.

Pasticciona0

I have never been able to make them without the boot, in any case, try and limit the uses of this pattern.

Pasticciona0

connect the cock in the serial is try to read it nothing happens if you mess up something if you can't read from serial port you have to force it in boot them up, then follow the instructions of the fg tech to be quiet....

philipcoin

hello mate,

please did you successfully read this ecu

thanks

regards.

Pasticciona0

hello mate,

please did you successfully read this ecu

thanks

regards.