cloning sid 804

[tecnoecu]

[cinqueturbo]

You copied only the Flash..
the eprom?

[tecnoecu]

hello nn I copied because it's usually for scodificare part of this type of ecu I just need the data flash.this if I'm not mistaken, the eeprom on the door from the opposite side to the processor right?

[sportknight]

yes, but the data of the bsi ce them in the eprom then you'll need to copy the eprom

[tecnoecu]

ok I try and I want to know

[legendaryslave]

raises capacitors is the under

[amen]

Don't be afraid to break the connections of the capacitors, bend until you memory easy to desolder, it does not break anything, just two supportini of plastic, then when you put the capacitors in their place will come back all ok.

[legendaryslave]

Don't be afraid to break the connections of the capacitors, bend until you memory easy to desolder, it does not break anything, just two supportini of plastic, then when you put the capacitors in their place will come back all ok.

Up to a certain point, however, that by raising the capacitors and bend the pcb and then always with due policy

[tecnoecu]

then I copied the data from either eeprom or flash, but it was the machine nn part I repeat I have them copied on a ecu with the same nm hw

[amen]

Then must necessarily start, you enter the diagnosis?

[tecnoecu]

is in diagnosis enters

[amen]

And what errors do you have?

[tecnoecu]

hello excuse me then, I correct in the diagnosis, I told my collaborator enters into the body no, but in ecu engine

[amen]

Then you agree with me that there is some physical problem, the welds ok?

[sportknight]

I know that this ecu is cooked...

[tecnoecu]

hi then will update on the situation.I found another ecu with the same number of hw and sw before you put the hand I tried to see if he entered the diagnosis and it was ok after I disassembled it I cloned the eeprom, and replaced the flash with its original horsemanship all and nn part nn even part of the diagnosis, I put back everything as you first enter the diagnosis, but logically, the nn part.what would you recommend for me?

[amen]

Then you understand that the flash is damaged

[danyparis]

Hello ,
ECU SID802 , 804 and 806 are identical .
To clone must change the Flash and EEPROM.
Are already several times)

[tecnoecu]

no the flasks nn is ruined because if the mount on the control unit original of the machine part, I think that me this ecu to be cloned, perhaps it also takes the reading of the micro

[danyparis]

Can't read this micro ECU because no BDM

[claus]

you can clone it with the tool I terminal?

[claus]

I confirm you can clone with the instrument I/o ends, I have a 5WS40110C-T
Num HW: 9653447480
Num SW: 9648624280
SID804
lìho clonaa with a sid 804 5WS40075C-T
and the car is in the game

[Senna_90]

you you with I the terminal clones all without unsolder or open anything

[claus]

now I have to try and edit the file and see if you can start

[claus]

by calculating the cks with another program