Ecu Iaw 59f scodifica and writing

[ether]

Hi guys, I am a beginner and I just started to fiddle around on the controllers.
I have purchased a decoder and I'm dabbling in riverginare, and to remove immobilizer on the iaw 59f. I'm using the software mtuning 59f.
Reading a bit on the network I read that in fact not all units are equal, in fact there are hw010, hw610 etc etc. With this info good or bad, are read by the software itself. My perplexity was founded in the sw ... I read that in practice you can load the file *.ori only with identical sw, otherwise they freeze. But I where do I find the info the sw on the maps available? What software or hardware I should use to be sure that the map that I am going to load on the ecu does not send block the same ecu?

[egs]

The 59F are divided into two families: the HW<100 are Motorola; HW>100 are Siemens. You can turn the ecu just in case they are of the same family (motorola or siemens), the hw is the same (59F with 59F, 5AF with 5AF). The software is relevant, yes and no. Or better if you take a ecu 59F.M5, you can change it with another M5 without changing the sw. 99% are good the same even if it changes the sw.

[ether]

Ok. Already started to better frame the situation. But if I had to use different file *.ori (mapping of the bike in this case) of course, for units 59 F, how do I know if the mapping that I want to load on the ecu is compatible with one of the two "families"? How do I extract this info?
Then at this point, I riallacciò to what I suggested you: if I find two units , for example, the hw > 100 then siemens, on these I can upload without distinction a map that was written for siemens (with hw > 100)?