The slaughter with golf 4

[amen]

Good evening, today I wanted to try nyo4 with the picture of the golf to my brother, golf 4 1.9 110cv 1999, the framework vdo. Not finding any 24c02 I unsoldered the only memory is similar, a 4279g tle. The carprog not read it so I abandoned the idea, but in the risaldarla I ran the welder, I don't know if I have done damage, but on the picture does not come out of the km and the car turns on and off again. Do you have the connections to tour so I don't have to abdare every time on the machine? If I buy another picture then it works?

[cinqueturbo]

I see hard but really hard...
also because if and lost the contents of the eprom you are forced to is the coding of ecu engine and put it in motion
with another framework and not have the contents of the eprom to write or replace the above does not go in motion...
I do not know the carprog.. I use UPA caliper SOIC
still and always better to unsolder for having the certainty of a correct reading...

[amen]

Will update, I redid the solder and now it is ok, but the picture just turned on it makes a ticking like a time bomb, will be some hand to fix it? However, the fact remains that the carprog not read it, with the clamp and welded. I chose 24c02. It all started because today I got the digiprog and will not connect to the machine.

[cinqueturbo]

I'm happy that if it is solved almost everything in the best of ways...

[amen]

However, I was left with the curiosity, but if I take a picture at the shambles, then you just scodificare the eci, partially, or have to do?

[cinqueturbo]

However, I was left with the curiosity, but if I take a picture at the shambles, then you just scodificare the eci, partially, or have to do?

There is no S-code Partial VAG...
perhaps making the virgin (as New) you could re-code with VAG VAS etc
I will if I have to replace a framework for the defect inside I take the memory and the exchange and via...
for KM to hesitate tools that work directly from the evening..

[amen]

I start the digiprog for that but do not want to connect to.

[amen]

Another question, but the 24c02 where is it located? I have found only one that I have told you.

[zullo]

I with the vag com I go quiet, I read and write from serial port ;-)

[amen]

I have not tried

[cinqueturbo]

I with the vag com I go quiet, I read and write from serial port ;-)


Vag Com Command? you too...