159sportwagon

hello ragaezzi, as the title I want to read each ecu me7 an alfa 147 3.2 gta. and can read it in serial.and if I should read it to tour those of you who has the pinout?

ugoboss

you have to put it in the boot in every case, both on the vehicle and to the tour.

159sportwagon

Do you have a pinout

cinqueturbo

Do you have a pinout

Do you have a pinout

more specific there are different ME7..
do I have to do a search to see the 147 3,2 GTA ECU mount?
perhaps a ME7.3.1 ?

159sportwagon

You mount the me7.3.1

maurof650

Here is the pin out of the Bosch ME73H4

cinqueturbo

Because here you may burn the ECU someone can clarify what PinOut and the right one thanks..

ugoboss

just read above, there are two types of wiring for ME 7.3** one for the fiat and the other for the alfa and ferrari, just don't make mistakes, if you have the ecu in the car easily see that the car is, if you have only the ecu and not know who the car belongs to you must see through the numbers hw and sw.

munro

serial does not succeed to read/write this ecu?
(also of interest to me this discussion)

cinqueturbo

just read above, there are two types of wiring for ME 7.3** one for the fiat and the other for the alfa and ferrari, just don't make mistakes, if you have the ecu in the car easily see that the car is, if you have only the ecu and not know who the car belongs to you must see through the numbers hw and sw.

the ECU's are the same!! :eek: see name plate..

ugoboss

hello cinqueturbo the plates look identical in the photos for comfort of the person who did the photos (he used only one photo and changing the pin colored above), but I can assure you that they are made of different numbers,

hello munro to read it in the serial, you put that still in the boot, open the connector above by removing the hard plastic protection and then found the pin just stick a pin and the mass just as you do at the counter, you realize that it is in the boot because in the picture you have the light code is turned on. and read and write from the serial port.

munro

you were,

hello munro to read it in the serial, you put that still in the boot, open the connector above by removing the hard plastic protection and then found the pin just stick a pin and the mass just as you do at the counter, you realize that it is in the boot because in the picture you have the light code is turned on. and read and write from the serial port.
good to know, thanks ugo....