Before reading explanations!

[project]

Hi guys, I have finally started with the practice!
As the first reading I performed a reading in jtag a marelli 8GMF.A5 a mito 1.4 Mair turbo 170cv, the reading went well with a galletto V54.
now if possible I would like to have qualcge elucidation namely on what I have read.
I did the full read of the ecu and has saved me 3 files, one named .all one eeprom, and one that I don't remember.
I would like to know what are those three files for which reason I save 3.
then the wing nut I have the opportunity to read individually the Flash, micro and eeprom what is l and what l atra taken individually?
on that .all I've seen that I can open to go to work on the map.

[overbooster]

flash=motor data
micro=data processor
eeprom=encodings(keys,frame,...)

[project]

Thanks overbooster!
so as to operate on the map,egr,fap and anything else I should work on flash
immo,scodifiche on the eeprom.
and to perform the works of scodifica immo,luca stanca and delete the egr you can also do manually without the use of software that do the job?
what?

[overbooster]

If you know what to do you do them by hand or need here on the forum which you can find many guides for software in the Home you will find the whole list

[project]

thanks a lot!!

[project]

I tried and delete the oxygen sensor with time, now if I want to try to check whether the software has done a good job how should I do?

[overbooster]

compare the mod file with the ori, and see if you have changes

[project]

with ECM titanium? because with ecm titanium I tried to compare,I opened the 2d graphics but it seems that they are the same even the wording changed, writes no

[overbooster]

It may be that it has not changed anything...

[project]

load the file ori and mod file. lambdaoff on the map I have not seen changes the only thing I found different is the checksum, is it possible?

[franco75]

to 1f7aa8 you of the changes, you are probably out of the driver from the ECM, and then you mark the changes but the file is modificatp. Unfortunately I can not tell if the change is correct.

[project]

thanks franco! I went to see I saw the changes!
now I have a couple of questions for you if I can!
I have noticed that the checksum is changed, is it normal?
you which software you used to find it? and you had to pass the whole map to find the change?

[ugoboss]

what you have loaded you is the complete reading, you need to work only on the flash, otherwise the files can not be recognized, and in each case the change that there is not cks.

[franco75]

I used the ECM, at the bottom, there are buttons with the line of red and blue and a black arrow who are looking for the difference between the two open files.
The Checksum, in view of the changes, of course, has changed

[project]

thanks a lot guys!
is ugo is the complete file, I did not know that you had to work only on flash thanks!
so I now know if it is actually the change has been made, I should of course try but to know it so I should know the addresses if you have those!
to know the addresses of the map how can you do?

[ugoboss]

for the addresses we want her to damos and use it with winols.

[project]