clone the ecu FIAT PUNTO EVO 1.3 75HP MARELLI MJD8F3.GG

[gianni1001]

Good morning to all
I would like to make a clone of this unit
Marelli MJD8F.GG
HW1FL 2841-GG44
55255946

in order to avoid making unnecessary purchases could someone kindly explain to me what the acronyms I have to take into account to be sure that it is compatible?
Thanks to all

[ugoboss]

hardware MJD8F.GG HW1FL
software 2841-GG44
number fiat 55255946

if you use the sw that you have already you need a controller with hw equal.

[gianni1001]

Thanks a lot
Friendly

[gianni1001]

Sorry
is that the ecu is only possible to read it in the BDM ?
however, it is written, even in the OBD'?
Thanks again

[cinqueturbo]

Sorry
is that the ecu is only possible to read it in the BDM ?
however, it is written, even in the OBD'?
Thanks again

Not in the BDM, but in J-dag..

[gianni1001]

ah ok ,I've never done it in that mode
and it's particularly annoying to open and read, or it is in the standard?
if you have any tips are welcome ;)
Thanks

[cinqueturbo]

ah ok ,I've never done it in that mode
and it's particularly annoying to open and read, or it is in the standard?
if you have any tips are welcome ;)
Thanks

Na rongia!! ;)
to open it, open it,
but to dismiss it as before I do not think it is possible...
reading and writing is always dependent on your tool..