the elimination of the start&stop from the map or not ?

[Alessio93]

[jolidj]

on which machine you have to delete??

[Alessio93]

[.Antonio.]

I'm curious too to know if ? possible.

[Alessio93]

up to now my parts don't ? managed anyone to delete it .

[michele30]

I know that you can make it , I read long ago somewhere that a guy had done on a punto evo, and had been touched of the torque limiters that work on the basis of the start&stop', but don't ask me what why? I do not ever did.
I ? was asked some time ago to do this on a giulietta 2.0 but then the customer not me the most said nothing.

[Alessio93]

[Engine83]

I honestly do not know how to delete it, but it should work on the basis of the temperature?

[Engine83]

I also take me :-) someone knows how to delete it on the bmw 320d 177cv

[Alessio93]

I don't think that functions on the basis of the temperature of the engine.... but based on the location of the exchange

[michele30]

start&stop working with a number of parameters and sensors, sensor, battery sensor, depression, and c'? who says that you can also just disable this? disconnect the plug from the sensor on the brake booster on and off from the map of the dtc.
I have also read that some diagnostic software does disabling from the body, but I have both brainbee that autocom but it does not do.

[clabsport]

I also take me :-) someone knows how to delete it on the bmw 320d 177cv
If I remember correctly with KTS disable the function.

[Engine83]

Thanks a lot I did not know with kts, tomorrow if you bring me the car I give him a look

[V.V.]

I also take me :-) someone knows how to delete it on the bmw 320d 177cv



On the Fiat you can? do with Multiecuscan on all ECU Bosch, Marelli, it may be necessary to switcharlo ECU worth the lack of start of the engine.

[Alessio93]

there would not be a sw that make the most of the car ???

[V.V.]

There is no need Damos and not even that, if incomplete, may suffice.

[alien78]

I also take me :-) someone knows how to delete it on the bmw 320d 177cv
for the bmw you just go to the dealership and you can disable it with the official diagnosis......
for the 1.3 mjt I found this but I have not yet had the opportunity to try it out

[alien78]

since ecm them to me as torque limiters midnight....

[pincopallino1966]

hello guys, I have some request like that, if someone knows something of it, thanks a lot

[V.V.]

for the bmw you just go to the dealership and you can disable it with the official diagnosis......
for the 1.3 mjt I found this but I have not yet had the opportunity to try it out
For BMW, you can do it alone, as explained in one of the previous posts, for 6F3 do with MES.

[mate89]

for ford fiesta 2009 you can?

[V.V.]

Also for EDC16C34, tested!

[michele30]

conditions of failure to stop motor

With the active device, the engine does not stop in the event of:
- the engine is still cold (sensor signal of the motor temperature is less than about 40?C);
- battery is not sufficiently charged (state of charge is below 75%), or, if it is detected malfunction of the sensor and the battery charge detected;
- a depression in the dell?braking system, detected from?suitable sensor, for example as a result of repeated pressure on the brake pedal;
- regeneration of the particulate filter in the course (only for Diesel engines with DPF);
- malfunction of the voltage stabilizer
- rear window defroster activated (assumes the willingness? dell?user to make the demisting of the crystals, for which ? should the engine to remain turned on in order to make available the hot air and/or conditioning)
- windscreen wipers working at maximum speed? for pi? 4 sec (it is supposed that in this condition there are adverse weather conditions as a result of which ? it is desirable to have the maximum driving comfort);
- driver door is not closed;
- safety belt-driver not connected;
- reverse gear engaged (in order not to prejudice the guidabilit? during parking manoeuvres);
- with automatic climate control, if it has not been yet reached an adequate ****llo thermal comfort (temperature, air conditioner set up by the customer with the difference greater than 4?C compared to the temperature inside dell?the passenger compartment), or enabling the MAX-DEF;
- malfunction detected on some of the sensors or systems
- in the first period d?use, for initialization of the system.
- air temperature is particularly cold, if the expected l?a specific indication.
In the cases above ? visible an informational message on the display and, where applicable, the flashing of the indicator light on the instrument panel.

[franco-electr]

I have a mito 1.3 2012 you can delete?
I mean the start and stop

[franco-electr]

I have a mito 1.3 2012 you can delete the start and stop

[maku1977]

with the latest version of multiecuscan you can disable

[maku1977]

I think from 2.5 onwards