Question about pcr 2.1

[.Antonio.]

I ? had a doubt on this ecu.
I read on the forum that before you can make read and write operations, this ecu must first be unlocked.
For? non pu? be unlocked ir? for a time, at least so it says in the manual of the cock.
Now my doubt ?, but com'? can tell if the ecu is unlocked or not?
By id ecu cock to me to communicate?

[.Antonio.]

I had already asked in another discussion but it was an off-topic and I never got a response.

[.Antonio.]

No one helps me?

[rodcraft86]

you connect to the obd and try to read, if not the law ? locked

[pincopallino1966]

hello,

theoretically it should tell you already? your HW as much as you colleagues if ? locked or not... at least other HW they do it without problems.

[.Antonio.]

you connect to the obd and try to read, if not the law ? locked

But not the risk of planting the ecu though ? locked and I try to read true?

[.Antonio.]

hello,

theoretically it should tell you already? your HW as much as you colleagues if ? locked or not... at least other HW they do it without problems.
But also the hardware clone? I have a galletto V54 clone.

[pincopallino1966]

But also the hardware clone? I have a galletto V54 clone.

I'm sorry but I can't say, I honestly only use HW drivers, I do not trust never to work with HW that does not give a safe standard? ;)...

[.Antonio.]

I'm sorry but I can't say, I honestly only use HW drivers, I do not trust never to work with HW that does not give a safe standard? ;)...
To have a huge amount of work in such a way to afford it would also be my theory.

[rodcraft86]

does not block anything go quiet

[ugoboss]

to read it does not lock anything, it crashes if you write a file that is modified (does not start), but if you rewrite the file ori you unlock, the cock will not tell you if ? unlocked and if the ? and do the unlocking yourself riblocca.

[.Antonio.]

to read it does not lock anything, it crashes if you write a file that is modified (does not start), but if you rewrite the file ori you unlock, the cock will not tell you if ? unlocked and if the ? and do the unlocking yourself riblocca.

Ah ok. Then I work normally from the obd read and write, if the car starts after the change, everything is ok.
If the car is not starting, load the file ori, I remove the ecu and proceed with the unlocking?

[ugoboss]

you should take it apart and look at it and well, these when you open a sign as you leave him, ever, if ? virgin open ? breakouts.

[.Antonio.]

you should take it apart and look at it and well, these when you open a sign as you leave him, ever, if ? virgin open ? breakouts.
Ok, thanks a lot.
I thought there was a way to be sure that it is unlocked or not.

[cinqueturbo]

I'm sorry but I can't say, I honestly only use HW drivers, I do not trust never to work with HW that does not give a safe standard? ;)...

Well The Ori Are The Casino..

[.Antonio.]

Well The Ori Are The Casino..
Vabb? in that case, you have a minimum of assistance.

[ghironfa]

you connect to the obd and try to read, if not the law ? locked
read always read....? in writing that ? locked.....

[.Antonio.]

read always read....? in writing that ? locked.....
You doubt if it was trying to write with the ecu locked the ecu stops or I was simply prevented to write.

[sportknight]

read always read,to write, instead, go only if ? unlocked,if ? gi? unlocked and try to unlock it, the re-lock and then stop writing.
careful why? the writing is not responding immediately, but almost at the end

[.Antonio.]

And if you lock com'? can recover it?
? a bit annoying having to sit with the anxiety that the ecu is locked or not.

[sportknight]

if it is blocked, why? the eprom was already?unlocked just replace the old eprom and write in the serial flash without the ecuid..

[.Antonio.]

I read in another post.
Thanks again for the clarification.

[fabioefra44]

you connect to the obd and try to read, if not the law ? locked

The pcr 2.1, you can safely read from or without unlocking them,the problem is in writing