MALEDUK

Hello, and can program a control unit drive through the comb.What kind of programmer serves,

amen

If you want to program using the pin of the ecu, can you? do without problems for example with the cock, you just have to have the pinout to know which pin to connect the wires and the game ? done.

silven

If you put it in the boot, many units almost all of those that you normally do via the obd do not allow themselves to write with the pin for the simple reason that the tour is not recognized by the immobilizer, and then the control unit stops the writing.

MALEDUK

There is a programmer that reads and writes through the pins of the comb without opening the unit or clone it

baraldino

Some dedicated tool c'? but typically make only a few Ecu
what should you do?

amen

I was convinced that any ecu to read from the obd it was even from the pin, once I wanted to read an ecu of a Lancia Ypsilon 1.3 of the 2010 and read only empty files, can? also be for that? It was not important so I did not have the bdm, but me ? remained the curiosity

silven

11-12-2014, 13:25

I was convinced that any ecu to read from the obd it was even from the pin, once I wanted to read an ecu of a Lancia Ypsilon 1.3 of the 2010 and read only empty files, can? also be for that? It was not important so I did not have the bdm, but me ? remained the curiosity?.

Your theory would be correct,the problem ? in the majority of the units present the immobilizer is doing the "dialogue" with the ecu,but when you simulate the power of the framework to the tour (powering) the immobilizer is not recognized, and here is the write lock,normally reading them? you should do it.