fiat panda stop do not work

[pietrotuning]

guys me ? entry into the workshop on a fiat panda 2006 petrol. do not work the stop key and the pedal ? new just replaced. I followed the electrical system and the signal of the brake switch comes to the body, which then should send +12v to the lamps. but the body does not come out of nowhere. also I managed to intercept only the thread of the stop left. the other two? has anyone ever removed a body like that or had a similar problem?

[Alessio93]

check the fuses of the body ,then check the masses rear and in front of the body .. let me know hello

[lupeen90]

check in the curve between the hood where they spend the wires

[clabsport]

Hello, I the advice of colleagues and do not underestimate some plug sfiammato, the rest in the car everything is ok in the diagnosis, what do you find in alignment ok?

[lupeen90]

or some spinottiera oxidized

[beppe.c]

check in the curve between the hood where they spend the wires
most of the time this happens.

[lupeen90]

the ? also happened to a friend of mine||

[lupeen90]

have you solved it then?

[jack91]

I have encountered the same problem on 3 500 and there were the broken wires in the curve of the hood

[franco-electr]

but The range on the switch of the stop there is

[sno74]

There are many problems on the spines of the body.......

[BlackFog]

Check the slopes of the body.. Maybe the resistor on the track power in the stop (located on the wire that enters in the body, open the bodi and follow the track in the copper that wire) skip

[t-jet46]

happened to me too...broken wires..

[walter_ie]

According to me it is the body, those body are very delicate, a Panda has done rognare to me, then I remember that there was a defect of one pin of the body and the track of the mass jumped inside, open it so it is simple enough and see if you see something broken.

[BlackFog]

Certainly, it is a problem of the body

[ciccio84]

Peter, you fixed it!

[leo_sg]

- check the diagnosis on the states if the brake signal works