The problem with Kessv2 EDC17C42

[gianni1001]

Good evening to all
I read in the Tricore said control unit with kessv2 clone doing the backup
Everything worked fine, but one thing I did not go back
When I tried to do after reading reached 100%in time to save the file it tells me "fatal error, the program will come from? closed"
And it closes by itself....
For? in the folder I actually find the file even if the error ? the program is closed.
I know someone kindly give an explanation of everything in there??
Thanks

[Streetracer90]

Hello Gianni!! But the file you open it or tells you not ? a valid file? Maybe you know sometimes with the clones can happen to these things

[gianni1001]

you're right
but the strange thing is that the backup did it quietly and, instead, read to me from this issue
it is a strange thing
if it was a problem, according to me, would not even up...or am I wrong?

[gianni1001]

maybe someone has already read this ecu in tricore or other models with the Kess v2 2.06 clone?

[frantik3]

to be sure, not ? a protocol that goes well and the backup you do it anyway

[gianni1001]

No No ? a problem of the protocol already? tried....

[gianni1001]

Update on the situation
After you have insisted on reading in Tricore with kessv2 clone I finally managed to read it
I don't know how the mystery of the universe at the end of the reading, it gave the error but I put l? with a calm and an 8-minute read
After you have saved and changed with Ecm finally I prepared to read it
But. Nothing
She has now decided not to write it
I also tried to supply the module with power supply pi? sturdy but nothing....
Does anyone have suggestions?
Thanks

[Mikigor]

That gives you the error ? What do you use kess module tricore? You may try ac connect the pin to the boot of the ecu with a 1k resistor and put it to ground and leave the cable grey disconnected.