PDA

View The Full Version : fiat stilo edc15c info



fabiovts88
hello to all
I would like to know the info , today I read a fiat stilo 115hp edc15c I noticed that while I was reading turns on the fan, I would like to know if I can write it without any problems or do I have to put in the voltage of the battery? there ? ever happened to you?

dvdtuning
You ? normal...put a battery in parallel or charger stabilized.
Even if you write it seems to me that not depart....

fabiovts88
Ok , I also noticed that the water temperature was at zero, and immediately after, they turned on the fans

Driver

fabiovts88
I hope I read with kess v2 and told me to change the speed? from maximum to minimum if no I could not read it... I broke down in writing

Driver
No worries... If the bad luck hangs most of the times the force in writing and writes the same. I usually do that with the rooster 53 but I think Kess go well

Alfiuccio
you should have no problems......talk about a kess clone?

fabiovts88
You kess clone v2 have you ever had similar problems ? I would not lock it in writing

blackwolf76
leave the fans why? the body loses the signal from the ecu and not knowing the engine temperature and sends the fans to the maximum possible protection for the engine. write problems, not you, even if you may stavvare the wire from the fan or remove the fuse.

nico2610
with a charger to keep the tension and you're comfortable

fabiovts88
Ok thanks guys it was to not do any damage to the point I'm out the fuse and put the battery in the voltage

angelolsp
exact off and put a battery charger..***** s, both the writing takes a little

legendaryslave
03-09-2014, 02:03
Staccale if fan for safety