People

[nico2610]

someone has read and written to people fc8 coup? with kess v2?

[nico2610]

any advice on this?

[ugoboss]

you should at least say that the ecu mounts, I made one and had marelli with micro spansion and made in the bdm.

[nico2610]

you excuse ugoboss brings me the coffee Saturday as soon as I see it, I write what it is

[nico2610]

ecu kohler ked3c2970-0

[nico2610]

8453 am attaching a photo but I don't think is feasible

[ugoboss]

these equip the new engines lombardini, ? an american company, the last I see.

[Engine83]

hello ugoboss to me ? happened just yesterday, a machine that mounts marelli, I did the reading in the k line with the kess but I didn't trust it and I wanted to make it in the bdm. you for if you have tried to make the scriptures serial?

[ugoboss]

I with the kess are not able to read it, you that the protocol you used? the read with mpps with protocol ypsilon in line-k but are not managed it gave me always the error, the read with the cock, v53 (file, 2.5 mb ) but even that's not me in writing.

[Engine83]

you read in kline both micro and flash an hour and a half of reading... now I try to read it in the bdm so bad I have everything saved and then I try to write. while with the management at the end of a 1,3 :-) have you had any problems with the setup?

[ugoboss]

that you read in k-line I am sure, but with which protocol (which drive)? a mjd6f3 but it takes little changes , you have to give a lot of naphtha and let it smoke a bit.