Info reading Punto GT, obd or read the chip?

[darioz90]

Good evening guys, I have a question to ask you... given that the punto gt ? no obd from what I know you have to remove the chip (fortunately, the car in question have already? proceeded to weld the clogs)

thanks a lot

[fabiovts88]

you should buy an eprom programmer type willem with que

[fabiovts88]

llo you should read and write to the eprom

[darioz90]

ok fine, but my question is always if ? can read this type of car with the KessV2 or Cock V54 in any way via obd\3pin etc

[fabiovts88]

with the kess v2, you can't read it, the only way on these cars a bit older ? as described above

[darioz90]

I have found the USB GQ-4X for win7 and ? gi? usb, I know that someone uses it...? I also know someone who reads without removing the chip ...

[fabiovts88]

this I could not tell, but the eprom ? zoccolata?

[darioz90]

[fabiovts88]

I suggest that the programmer costs just put it on and read and write

[ugoboss]

I have found the USB GQ-4X for win7 and ? gi? usb, I know that someone uses it...? I also know someone who reads without removing the chip ...

these do not read nor the write by obd, have the eprom and not flash, then dismount and you read and write to the tour, and to write them down, you have to first delete rays with u.v. (as long as they have the louver)

[darioz90]

[ugoboss]

do not delete, to delete them you have to take a eprom eraser ray U. V.

[darioz90]

are you sure? have you ever tried to use it, GQ-4X or seen used by someone? I know otherwise....

[ugoboss]

the GQ-4X ec as the other programmers-the-counter, I repeat to you the eprom the gates only if they have the window above, with the rays U. V. if you do not have not the gates and replace, then you can always try.

[darioz90]