Kess and problems in reading, writing...

[Rebound]

Hi all!
I have always worked with the ecu on the bench, avoiding read/write via serial...
I wanted to try from the serial with the Kess with a Bwm 520d.
Read me asks for the value of the resistance...and write me says checksum error...
Where do I get the correct value of the resistance? checksum error why? the ecu is not ? supported?
thanks in advance!

[mafani]

hello, but you're talking about kess 1 or 2?

[Rebound]

I'm talking about the kess v2

[rodcraft86]

very strange, that the ecu mounts?

[mafani]

should be a edc16c31, however, strange

[rodcraft86]

the c31 the flight, perhaps c'? anything that interferes with the software, on which operating system did you install it?

[Rebound]

Use xp sp2...and the software suite k has caused me a few issues...
However, the interface and a clone

[rodcraft86]

then do so, install win7 32-bit and retry, you'll see that it works well, for xp you need at least sp3 32-bit, on 64-bit systems, the clones have some problem

[Rebound]

then I installed the k-suite on 2 laptops, one with xp sp2 and the other with windows 7 32-bit:
on xp is giving me the problems described above;
on windows 7, k-suite does not start with the kess...
I'm hacking to get it to work but I am left with the conviction that ? better to work at the bench with the ecu... am I wrong?

[rodcraft86]

you need to update the pi? can win7 and then download the visual c++2005 or 2008 you will see that it works

[oakley1]

Hello.. Do Not ? if you have other ftdi drivers installed on the pc?

[rodcraft86]

also this could give you problems ? true, I had uninstalled everything, and after the installation on their computers, reinstalled the rest

[oakley1]

For the rest, what do you mean? Other programmers with ftdi drivers? Not good

[rodcraft86]

exactly, for example if you have installed mpps or elm327 or the wing or the other, there may be conflicts

[legendaryslave]

install the k suite ori then the disistalli and put your version

[sno74]

shares in full Legend is ori do not connect toll remove and put the installation of the clone, then test to see that you are OK.......

[Rebound]

ok I will try and tell you

[oakley1]

Why? install on their computers ori?

[Rebound]

uninstalled everything...
On XP I have installed the k-suite ori, uninstalled and installed the clone... still no go...
On Windows 7 the same procedure but on this operating system does not open the K-Suite...
interface problem?

[sno74]

But you recognize the usb interface.

[Rebound]

on windows 7, the program does not open, on the windows xp interface the law, but when I am going to write to me says "checksum error"

[rodcraft86]

you have downloaded visual c++2005?

[Rebound]

...downloaded and installed

[robo]

? a rare that won't work...

[19antonio192]

install the v2.06 try and let me know