ford fiesta sid802

[francescosparco]

hi guys. I would like a information. should I close the egr on this car-ford fiesta 1.4 tdci 68cv siemens sid 802 . I wanted to know just put the sheet and I have no problems spia. I do I have to delete electronically? because the more I look at the map the more I can not find where to delete it

[elettrocar78]

hello if you have the egr valve pneumatic, you can put the plate and solve the problem, if it's electric you have to detach the connector and then you have to go to delete the dtc from the flash .

[francescosparco]

and 2005 year.. I think I still pneumatica.se in this case, the light comes on if you place a l ori I know to locate the dtc?

[elettrocar78]

if it is pneumatic putting the plate does not turn on no light ,if it is power by unplugging the egr after a while you light up the light,at that point you make the diagnosis, and you will write the dtc,if you want to send me the flash and the two dtc and delete it,hello

[francescosparco]

Thanks very friendly tomorrow the day after tomorrow I put hands and I'll tell you.

[polini]

hi guys. I would like a information. should I close the egr on this car-ford fiesta 1.4 tdci 68cv siemens sid 802 . I wanted to know just put the sheet and I have no problems spia. I do I have to delete electronically? because the more I look at the map the more I can not find where to delete it

Go to the sheet and not ignite? none of the indicator lamps.

[leandro89]

if it is pneumatic putting the plate does not turn on no light ,if it is power by unplugging the egr after a while you light up the light,at that point you make the diagnosis, and you will write the dtc,if you want to send me the flash and the two dtc and delete it,hello

what do you mean by "me"?

[betrescudan]

what do you mean by "me"?
it means that the law of the flash,the dump, sends it through e -**** and then reflash the ecu dump mod file...but how to send and-****?....maybe with the regular mail?or post the dump in the forum, and the one that has more than 80 posted messages,it can see,or modifficare

[francescosparco]

sorry I'm wrong. come to the customer in the workshop.. and the new ford fiesta sid804, and the same thing"

[betrescudan]

you have to read the flash...try with galetto, or kess

[francescosparco]

S? tomorrow I'm going to read with the cock .you must delete the dtc or how? I have dtc remover. Can I fix this?

[betrescudan]

erase the mistakes,then by the law of the flash

[polini]

sorry I'm wrong. come to the customer in the workshop.. and the new ford fiesta sid804, and the same thing"

? the same thing

[elettrocar78]

to me, it happened a short time ago and the procedure is the following: the egr valve and will definitely electric,you will have to remove the connector so will always closed, put some in motion see the light engine does not light up immediately,once turned on, make a diagnosis and write the two error codes.then you will have to read the flash and with the appropriate program you'll need to delete the two dtc. once deleted, you will be able to rewrite the flash.if the tool you use does not make the checksum automatically you will have to calculate it before writing to the flash with a special program.