Sign in

View The Full Version : Audi A4 (B8), 240 hp, 3000cc which interface to use ?


corrado
13-07-2014, 20:18
As the object I wanted to remap this audi ,
I was able to read the map with the V54, but write it I do not want to know ( OBD)

I can advise on which interface ? able to do it ?
guidotacco
13-07-2014, 20:22
that ecu mounts?
corrado
13-07-2014, 21:07
that ecu mounts?

EDC17CP14 Bosch
faberecu
14-07-2014, 00:08
read in boot of that year ? always do a reading in the boot , then do all the tests that you also want to obd
guidotacco
14-07-2014, 08:56
read in boot of that year ? always do a reading in the boot , then do all the tests that you also want to obd

I,not without risking having his backup!
corrado
14-07-2014, 11:28
read in boot of that year ? always do a reading in the boot , then do all the tests that you also want to obd

? 2008 ... ok for reading in the boot , which instrument ? preferable ?
sno74
14-07-2014, 12:17
I always use ktag for these also the v54 ? good follow patterns and resistances that you call the PDF for the chicken........Then, as it says Faber when you have BK bed in the Bott do all the tests that you want to be in seriale.........
corrado
14-07-2014, 19:17
I always use ktag for these also the v54 ? good follow patterns and resistances that you call the PDF for the chicken........Then, as it says Faber when you have BK bed in the Bott do all the tests that you want to be in seriale.........

with this ecu you can't? use the template right ?
corrado
22-07-2014, 10:44
I always use ktag for these also the v54 ? good follow patterns and resistances that you call the PDF for the chicken........Then, as it says Faber when you have BK bed in the Bott do all the tests that you want to be in seriale.........

the kess f? in tricore boot mode with a direct connection ?
ugoboss
22-07-2014, 12:21
if ? a edc17cp14 you have other links on the comb you only have to solder the wire to the boot, or if you have a e xxx a needle use the one with the template.
corrado
23-07-2014, 19:53
if ? a edc17cp14 you have other links on the comb you only have to solder the wire to the boot, or if you have a e xxx a needle use the one with the template.

goes well with that not official ?
ugoboss
24-07-2014, 07:46
goes well with that not official ?

the discourse ? always, usually, depends on the quality, I have a v48 and a v (53), and so far I always did with no problem.
corrado
24-07-2014, 10:37
Thanks Ugoboss , I'll try with the v54 seen that I have run already? readings in BDM with no problems, but never on a edc17...
Do I know how ? gone

thank you all so much ;-)