PDA

View The Full Version : EDC16C39 - Information on the map conversion Nm/IQ


everyname
07-07-2014, 17:28
I'm doing practice on a EDC16C39 and I would like to ask you if I have understood well the meaning of the map conversion Nm/IQ.
This map, with axes, with the axes of Torque/RPM, it indicates how many mm3 of diesel fuel are needed to obtain the required torque at a certain rpm so if you want to ask more? couple of that provided by the original map, modified to run on this map is to extend the x-axis (torque) to inform the controller how many mm3 of diesel fuel are needed to obtain the new maximum torque request. ? correct?
Already
07-07-2014, 21:23
more often than not, the edit of this map leads to an error P0660 "error calibration ecu" when you do not change PROPERLY. I'd be well I want to know how to correctly edit this map
jacktheripper2
12-07-2014, 21:42
more often than not, the edit of this map leads to an error P0660 "error calibration ecu" when you do not change PROPERLY. I'd be well I want to know how to correctly edit this map

You just need to follow the trend of the map and do not have problems with error calibration ecu.
everyname
14-07-2014, 10:04
You just need to follow the trend of the map and do not have problems with error calibration ecu.

Thanks Jack for the confirmation :)
biela
21-07-2014, 15:12
Has probado extrapolaci?n lineal?
Link deleted
Greetings

Have you tried linear extrapolation?
No excuses for it.
Backgroop
21-07-2014, 17:18
Has probado extrapolaci?n lineal?
Link deleted
Greetings

Have you tried linear extrapolation?
No excuses for it.

It is forbidden to post external links, I invite you to do the most? attention
biela
21-07-2014, 18:40
Y = ( ( X - X1 )( Y2 - Y1) / ( X2 - X1 ) + Y1

X1, Y1 = First coordinate,
X2, Y2 = the Second coordinates,
X = target X-coordinate,
Y = the interpolated Y coordinate.

Greetings
enzopezzano
22-07-2014, 18:54
Personally, I have never had that type of error is also increasing significantly.
Already
22-07-2014, 22:24
I just wanted to keep the 100mm3 to increasing rpm, and has given me this problem. YOU have to mod the maximum values?
enzopezzano
23-07-2014, 00:17
On some. A good 150 prepared by the track for example.
tecnoecu
17-08-2014, 14:15
he begins to work with increases in low and see how it behaves in the car