ktag write e2prom edc16 c3 peugeot 206 1.4 hdi

[Alfiuccio]

Hello all....I have done a reading e2prom and a control unit for peugeot 206 edc16 c3 1.4 hdi to make the scodifica.....so far everything is ok.....processed the file I write....all ok write done correctly.....I reread again the e2prom and is equal to the ori....I wonder why it does not write to the e2prom? on the flash all ok....Thank you all in advance....
P.S ktah=clone

[alien78]

have you checked the two files(ori and mod) before writing? why? many times the software will say the operation is successful, but in truth? do not change anything

[Alfiuccio]

hello alien, thanks for the collaboration, however, the change of the file was made....in fact, I've rewritten several times the mod file but when I reread I get out of the file ori as if you have not made any modifications.......

[Alfiuccio]

problem solved with the cock....the scriptures done correctly....the problem is on my ktag that does not perform the writing....

[djole]

good files

[danny677]

good files

but with your brain you can understand that with all the spam you're doing to the community sparirai from the forum in a few hours ??

[madymax]

I had the same problem with a Mazda 3 1.6 d ecu also edc16c3
If you will pay attention at the protocol''s eeprom and the eeprom on the ecu you will see it's different size.
One is 95160 and kess is expecting 95640.
I DO not use kess on writing EDC16c9 eeprom.

[Giuseppetecnocar]

Pleasure Joseph, I recently bought kessv2 clone I tried to read a citroen c3 1.4 hdi cn unit siemens and tells me that it must be read in via the can or kline, but I don't know where to connect the pin you could tell me where to find instructions, thanks in advance

[cinqueturbo]

Pleasure Joseph, I recently bought kessv2 clone I tried to read a citroen c3 1.4 hdi cn unit siemens and tells me that it must be read in via the can or kline, but I don't know where to connect the pin you could tell me where to find instructions, thanks in advance

This is a snag that you will often find on the different cars..

I I have done a little bit of experience and I'll give you a simple piece of advice,

depending on the age of the car, select the protocol that is (K-line less-recent) (Can recent) you may also find the K-line Can set in vehicles VAG and speech and similar.

however, you can read it in both ways, not "nothing happens" and compare to verify the files to be certain..

you can also see a difference in the speed of reading is sure to be another clue to add to the experience