Sign in

View The Full Version : Required transmission speedometer and adaptation km



xathanatosx
29-06-2014, 21:55
Hi I would like to know what I should buy, that grip and software, to change the speedometer and adjust km for a 159.
thanks

gionag
30-06-2014, 12:35
I on the 147 I have not had to do anything special. after replacing the framework, I used *********** to align the km.
as from software?... does not work in the back.. only forward, and then if you take a picture with the km > of those that you have in the ecu is not doing it.

in my case it was fine, why? the ecu reported 200xxx km on the odometer, it had 110xxx....

redfifty
30-06-2014, 13:00
For the painting, or that you get a programmer eprom, disassemble the e2p and resets, or there are tools that do that from the serial type, the smook tool.
For the ecu, I don't know, if you have to do the same procedure to disassemble the e2p, wait for the experts

xathanatosx
30-06-2014, 15:29
But not to do it from the obd?

michele30
30-06-2014, 21:46
with the cable of the smok make them quietly the framework for alignment proxi you need a computer diagnosis or *********** or many others on the market

xathanatosx
30-06-2014, 23:09
with the cable of the smok make them quietly the framework for alignment proxi you need a computer diagnosis or *********** or many others on the market

with multiecuscan you can only increase the km. the car has 87.000 km, and the new one I doubt that he has so few, therefore, in the case had too many miles well.....

redfifty
30-06-2014, 23:22
with multiecuscan you can only increase the km. the car has 87.000 km, and the new one I doubt that he has so few, therefore, in the case had too many miles well.....

precisely serial you need the cable smok... or I don't know if there are other hw

legendaryslave
30-06-2014, 23:57
Hi I would like to know what I should buy, that grip and software, to change the speedometer and adjust km for a 159.
thanks

if you must do it only for your car I think you have to go to a professional, the cost of the equipment and software would not cover any expense of the work itself