View The Full Version : emptying paraflu
macinische90
19-06-2014, 18:29
hi guys has anyone ever done the bleeding of the water as the old one(paraflu) with the new one? if you like it proceeded?
redfifty
19-06-2014, 22:03
Hello,
- open the cap of the water tank
- search in the lower part of the radiator on a faucet to drain the water, or if not c'? disconnect the tubing pi? low and leave empty the system.
- turn off the faucet or reattach the pipe
- fill the system and open the various drainages present, usually one at the top of the radiator and then depending on the vehicle there are drains on the pipe that goes to the passenger compartment or in other spots
- when the sludge exits the liquid chiudili
- warm up the engine
- when you open the thermostat all the pipes reach the same temperature
- wait until leave the electric fan cooling
- controls the ****bring the water to a cold engine
Erik
macinische90
19-06-2014, 22:17
well... I was afraid of ruining the water pump as well.... :eek:
hftdelta
20-06-2014, 21:50
I recommend you to reopen it and close again the purges after the process of connecting, be sure to delete all the air
giuseppeturbo
21-06-2014, 16:40
What machine are we talking about?
macinische90
21-06-2014, 17:25
Lancia delta
franco1971
21-06-2014, 19:21
I also add to the cars that have the heating faucet to put in place all warm if not the radiatorino the inside is left blank and see if it comes to a hot air
redfifty
21-06-2014, 20:34
I also add to the cars that have the heating faucet to put in place all warm if not the radiatorino the inside is left blank and see if it comes to a hot air
quoto in full, forgot :D
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.