info galletto 4 v54

[anniver]

prejudice or recently purchased the cock 4 v54 testing in serial mode it is fine for reads and writes a fairy tale


I'm testing in the bdm, I never did personally or only seen to do or recovery of the ecu to the sfasciacarrozza type marelli 6jf

from the kit I euscito one scedino that makes marelli, simens delhpi cmd, but I have to use the force I can not solder directly the wires above????:confused::confused:

[sno74]

Inside you have a pdf with all the instructions............

[faberecu]

balances male strip the female of the correct size , balances on the pcb and insert , remove the resistance from 0

[giuseppeturbo]

If you use the schedule to spring and more? fast and convenient, don't forget the bi to use e xxx cmd to be interposed between the flat of the chicken and the flat that goes to the ecu in the pdf you have all the explanations

[faberecu]

obviously not ....

[giuseppeturbo]

I understand that he has mine was only a council

[anniver]

in the kit are not out of the srip weld I wanted to fix everything saldandoli (flat ecu) since the schedule are not the other adapters( flat)( bdm ecu )I thought I would go back to the 4-wire to use and solder them at least for the marelli

[sno74]

If you use the schedule to spring and more? fast and convenient, don't forget the bi to use e xxx cmd to be interposed between the flat of the chicken and the flat that goes to the ecu in the pdf you have all the explanations

on the marelli e xxx ? direct...Flat e xxx stop important thing pin 1...........

[anniver]

voltage 3-or 5-v ok

for the pin 1 cme can I identify it??

[alien78]

here is the link.....:cool::cool::cool:

[Backgroop]

Discussion moved to the right section, next time do more? attention

[anniver]

here is the link.....:cool::cool::cool:


thank you the are the same images that document, or of the chicken 4, I mean the link without the use of schedule by welding directly to the 4 wires needed of the flat cable on the ecu.......