View The Full Version : Renault Scenic 1.9 dti not part
hello all,
after disconnecting the battery for operation of the mechanical on the car is not part of pi?...
the diagnosis does not enter the engine ecu , the immobilizer from errors.
I tried again to riverginare the ecu and the part with the light flashing glow plugs and try starting part and shuts down... scodificata the ecu: same problem...
problem ecu engine? suggestions?
thanks in advance!
Weird, what ? the exact model of the car and the ecu ?
Renault Scenic 1.9 dti year 2000 engine ecu Bosch 0 281 010 077
Renault Scenic 1.9 dti year 2000 engine ecu Bosch 0 281 010 077
What type or kind of work you have done on the car? when you have restored the clamp, the painting was turned off?
the mechanic told me that he had to disconnect the battery to work on the alternator...nothing else...
Hello and very strange I think that all happened because the terminal of the battery and unplugged immediately after turning off the picture and after about ten minutes, then prt speech lamp glow plugs verificherei that all the plugs are in place, I would do a diagnosis to see if there are any problems.
unfortunately, no diagnosis enters the engine ecu...
I also realized after detachment and riatacco battery would not start the most colego the clip is giving me all kinds of errors and I made them cancelere then the morning after, and the game as if it hadn't happened nothing
unfortunately, no diagnosis enters the engine ecu...
Check all power and ground to the ecu, checked the can network if mounted on the car
try to leave the ignition on for a few minutes.....I advise you to also check the continuity of the can network engine-obd has the L and H, if you need to look at the connectors and let you know.......
falla total ? messed up the immo
post7
made scodifica total...nothing to do...
made scodifica total...nothing to do...
If you do not enter diagnosis vuoldire that is missing the power supply to the ecu, or does not go to the can line in the worst case ? damaged the ecu, parts trying power+12 +15 +15/54 and the masses on the connectors, after checking the can network.
tried the fuses ? happened that blew some fuse and does not enter the pi? diagnosis
check continuity can line
how to check the can line?
the first control that you c can ? measure the resistance between the line h and the line l, a line can integrates must give as resistance 60 ohms if you find 120 ohm there some problem on the can line or on any unit connected on the line c can
try to connect it to the dealer and see if at least the control unit works
after checking the system, ecu engine I solved it by changing the body...
thanks to all for the help!
in practice on this car ? dangerous disconnect and reconnect the battery...apparently there are multiple problems that appear...and all the different...
Pu? happen that after disconnecting the battery the body,which can? be configured in 2 different ways with regards to the immobiliser,go in the block.Anyway, if you've replaced and it's fine,ok!!
sorry but with scodifica tot the machine nn should start the same, even if the immo in the body ? active?
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.