scodifica ecu bosch m.1.5.fiat brava 5 cc1.4

[glittering chiffon party dress.fitted]

As the title I should scodificare this ecu in partial or in total, I would ask the experts after gi? read other posts ,if immo decoding for the total goes well and if the ecu can read it or just write it thanks

[cinqueturbo]

Also interested in a m?..
or ME1.5.5 GM and non-or even tried to read it, why? or doubt on the pin out..

[sergiot]

you can only write to a file without immo

[sergiot]

Also interested in a m?..
or ME1.5.5 GM and non-or even tried to read it, why? or doubt on the pin out..

the me1.5.5 gm ? different from m1.5.5 fiat and the pinout ? different

[redline]

attention to the me of the fiat group to be made in the boot with good equipment

[glittering chiffon party dress.fitted]

I ask too much, since I've heard bad both of the telephone that...........x-a file already tested thanks

[cinqueturbo]

the me1.5.5 gm ? different from m1.5.5 fiat and the pinout ? different

For case, can you help me with the pinout?

[alfonsoh]

hello glittering chiffon party dress.fitted what tool did you read it? we read in the boot, it depends on whether your instrument lets him do. I suggest if you can do a reading with your tool, have it with an editor and compare it with the file that gives you the immodecoding

[biondo83]

Connect your programmer to the K line, as in the picture to the left and then with the tip shunting the point shown in the photo to the right.

[glittering chiffon party dress.fitted]

I mpps v 5. gallo v, 48 and 53 thanks to all

[biondo83]

I mpps v 5. gallo v, 48 and 53 thanks to all

For writing follow the directions in my photos.
The reading you can do it only on some of the ecu, it depends on the serial HW and SW that you have.