encoding injectors

[rodcraft86]

guys, I would like to know the steps to take to save and write the coding injectors "where possible," with autocom, someone has done it? thanks

[lightning]

Hello I try to reply to you I, autocom I don't know how ? structured ,however you have to go in regulation and the various adaptations, and between these and c'? coding injectors ( code ima),enter the code and then you do what gives you the tool,and you're done.

[rodcraft86]

thanks but I was referring to the autocom in the specific

[giuseppeturbo]

hello enters the diagnosis on the engine management if the sinistr of the screen you see a button with a key and English, and a screwdriver, cross-tab, and clicking on that button you'll face the fre adaptation. I remind you that the text and relating to adjustments to the engine management, and the possibility to perform this function varies from digosi and diagnosis, and it is updated

[Zac]

it is not difficult,you have to dig around a bit in the menu of the engine management,the items on the menu that will appear vary from the type of the drive and updating your software

[rodcraft86]

ok, in the men? c'? the encoding entry in the injectors but recodes them automatically, or is to save the encoding above, and then rewrites it to mo chicken?

[Zac]

I don't remember if you can save the previous change,then why would you do that? however, in the menu you will find (if it is a drive to the 4 injectors 4 series of codes)to assign each one to an injector, if the mountains of new injectors usually you should manually enter the numbers that are printed above each of them (should be 9 digits) in order from the first to the fourth, which would be the cylinders in the order in which the cil.1 cyl.2 cyl.3 cyl.4 in practice, I give you the example,you don't do anything that you tell him that on the cylinder 1 are you placing the injector no. akw549786 on 2 no. hqa534278, etc. etc.. I explained it ?

[rodcraft86]

ok zac, everything is explained, thank you