Lancia Ypsilon 2004 1.2 8v. gpl

[Exside81]

Hello, I have a problem with a ypsilon 1.2 8v lpg. did the oil change and oil filter I have reset the service. before the oil change the flashed the kh on the body and the sevice.
after the change I have reset the service and ? gone to good end ? remained flashing the kh on the display and the left as it was..
and the problem is that when I went to try the machine flashed the light engine was not fixed as usual and the car was fine at the minimum you off is hard to walk and putting the 4? almost stops maximum that you can? use and 3? gear what can? be?

I have reset the service with multiecuscan license and has never given me problems.
I hope that someone can? to give a straight.
Thanks!

[jovandj]

If flashing has a population of km there is something you want to align some node that is not and was cheered usually....for the technical problem, and a lot diagnose without error codes or other distance

[zullo]

usually when flashing the light engine must be adaptation of the crankshaft sensor
do just put in neutral and accelerates until it attack the rev limiter and then put to a minimum then riacceleri and then put to a minimum until it shuts down or becomes fixed.

[Alfiuccio]

errors in the ecu?

[Exside81]

As errors ecu neither before nor after the error light is giving me errors in the ecu.
I have also done the reset parameters autoadattativi for? I have not done the procedure that asks multiecuscan,I made the case...
I don't know if it could be the one.
x if someone has never done it?
thanks x the help!!

the car is not mine, and my friend and tomorrow I have to find a solution.

[guaro85]

for the flashing of the km you have to make a proxi alignment while the flashing of the light engine do as he says zullo

[Exside81]

Thanks guys! I followed the advice of zullo and the machine, and returned as the first has saved Me in the behind!! Thanks, really!
Guaro85 I did the aliniamento proxi and boulder affixed Thanks!
Thank you also to all the others!