reading the lancia musa 1.3 mjet 90hp

[159sportwagon]

hello everyone. yesterday I read with the kess a lancia musa 1.3 mjet 90 bhp reading and lasts approx an hour and a half I have told, and that this ecu can not read. I the ori after you have edited it couldn't write,not even the ori? some of them had one of this problema.questa and the idedificazione.HW: MJD6F3HW03T .M3
SW: 3056M350
VIN:
Ver.SW: 0000
Spare: 51784559
Engine:
Ver.HW: 00
SW agg.:
System:
the number of hardware does not corresponds neither with the one in the directory including search function .the file read and 2048kb

[cinqueturbo]

Or not well understood, but what you want to say or know..
I have had problems with the Muse and the same HW and SW
or resolved by reading it.
and then written in serial with Cock..

[alien78]

when you read with kess you have to go to utility selections 1.3 mjt and then choose ungroup the file divider? the micro from flash at this point you will have to mod the flash at the end you have to bring the file to write by selecting merge then the micro ori and the flash mod.
at this point you'll have a file that is compatible with scripture.

[159sportwagon]

Thanks alien for the help . Then I'll know

[polini]

I had always done a muse 90hp xro now I don't have on hand the sw and hw , the reading time more or less with gallo about 1 now, as then, I had not yet figured out how to cut and paste the file from the 2.5, I took a file from the database cut I wrote conil Magpro

[159sportwagon]

Then I can do reading and writing without the need to open the ecu ?

[carlo abarth]

I don't advice..go bdm with that car!!!
Then I can do reading and writing without the need to open the ecu ?

[alien78]

Then I can do reading and writing without the need to open the ecu ?
I've always done with the procedure you've described (as in the instructions alientech) and ? always everything went well, of course I use kess v2 ori with the clones, I can't guarantee anything.......

[159sportwagon]

I also use the kess v2 ori

[alien78]

then you should not have any problems myself of those ecu I've done a lot with this procedure, why? the kess pulls out a single file that includes micro+fash and if you change it without splitting most likely the micro is imperishable......

[159sportwagon]

If I split the file as the
Hack . Which one ? the difference between a file split and one full ?

[alien78]

once you have divided you change only the flash as all the other ecu then before rewriting it using the merge option, put together micro-ori with the flash mod, the difference between the two I already twill before kess v2 reads a file competing micro+flash but you have to mod only the flash

[159sportwagon]

7711 I do not do the writing . The mod was a separate modified and re-assembled .