MJD6JF software code does not match

[marco66]

I read with galletto 1260 ecu of my panda cross mjd6jf
and I noticed that the code hardware and software do not match.
Exactly on the label :
MJD6JF/HW02A/1092-S464
panda 1.3 SDE EV4 EODB 4WD

while ecu data with the cock :
MJD6JF01A 1098S454

I bought this car used a few months ago and I wanted to understand what caused this difference.
greetings marco

[ugoboss]

it's already happened to many others, this difference on the fiat panda, are outputs that's right , but I warn you that many have locked the ecu in writing with these numbers.

[marco66]

looking on the forums I saw that the problem ? in the hardware code 02A 01A by hex edit
For the difference of the software code will be a update ?

[egs]

You ? happened to me, but with another tool. In writing it ? locked the ecu, I don't remember if I had to take it in BDM or have I got another ecu.

[alien78]

but when you block write yes you can with the function recoveri of the kess

[jolidj]

it depends. sometimes the resume. the flaw in the bdm and go quiet

[leandro89]

to me ? success as well with mpps, write, run at 100% but the car would not start, rewritten by changing the bit in the mode? recovery directly and everything ? smooth yarn

[marco66]

Thanks to all for the advice, for the bdm are not the jogging and I would not risk my ecu. I think that to try I ought to find a ecu guinea pig.
I don't know if I ought to work on the file ori downloaded from the ecu MJD6JF01A 1098S454, or to a file ori found on the net MJD6JF/HW02A/1092-S464 that corresponds to the code of the ECU.
I think, however, encoding inniettori and key remain in the eeprom, however, I have read and, therefore, also uploading the file ori found in the network, the drive should still go.

[cinqueturbo]

I'll write your file with SW in the ECU to the bed, and not the one on the label..
then MJD6JF01A 1098S454..

[msport (exil77grande)]

also, if you write the file, and the blocks just do the hex editing,rewriting of the file and the machine part.

[ducati83]

hello msport, what change are you talking about?

[msport (exil77grande)]

hello msport, what change are you talking about?

in practice, I will explain:
this type of panda 4x4 with hw 01A often hangs in writing,to resolve the problem you need to require the file from hw 01A) 02A in fact, if you do a search you can see that there are both files are identical to the 99%,just go into the hex in the file with hw 01A and change a string to the address 0600BO and then change the value from step number 3 from BD 53 42 AC 2A 41 D5 BE and the game is done,if you cause both the file and go into the hex you can see the the same thing that I wrote.

[ducati83]

good information thank you.