reading ecu iaw 59 f or later

[michele30]

yep, I saw that there are several guides to read marelli iaw 59f or later in the boot, c'? none of you know if ? can do the reading with the k-tag?

[egs]

Certainly that ? you can read those for power units in the boot, I read them, cos? with a tool, for? for the k-tag I don't know. Not ? ori, right?

[michele30]

No No ? ori
but then not c ? solution to read it at least with the k-Tag

[egs]

With the K-tag, I don't know, should respond who has that tool for? I think that is the reading in boot-mode.

[michele30]

read in boot mode, but not for this .
Was wondering if anyone had tried it with some solution , even if I don't know which.

[alfonsoh]

you should make the boot is mounted on a stf10..... I would try with the protocol 5sf for 166a400 or 4af 188a4000 depends on the type of motor that mounts I think a 188a4000 then I'd go for the schemes boot of the cock l...

[faberecu]

on the ktag there are all the patterns in the sw . I have never tried it , to make it virgin or total use piasini in 5 min has the tool of reading in the boot eeprom 95080

[elmiky]

sorry faberecu I have tried with piasini to read 59f to tour but I get link error..

[faberecu]

you put the boot
?

[rdponline]

I confirm that you can read the 59f or 5af with ktag, not the protocol. And true co mountain st10f168 and st10f269, but using the protocol 4af in addition to boot you should also use another wire on the small marelli you would not have where to solder, because what you see when you open the box and are only the outer parts of the board...

[astriunfao]

hello. the use iaw marelli decoder this tool can read / write flash and virgin eeprom and immo off. work with 59f and more.

[robo]

You can? also use the Rooster clone has the function in the software inbboot mode, I made some, the only thing it doesn't do those with lower hardware 100