Replacement body computer stralis

[blackwolf76]

Do I need to mount a body computer used on one vehicle, so I would need scodificarlo or at the limit, replace the eeprom. I know how to tell it how to proceed??

Item code FV 41221000


Thanks.

[IlCurioso]

That stralis ?? Cursor 8 or 10/13? Euro 3 or euro 4/5 or 6?

[blackwolf76]

? a trakker 2005, cursor13 480cv no code. The body that I should mount ? was taken in the demolition and has the code active.

[ecutano]

? a trakker 2005, cursor13 480cv no code. The body that I should mount ? was taken in the demolition and has the code active.
Hello , you first make the program the Body will be taken to the demolition at a workshop Iveco ,just write the alfanumericode of the Body of the original , however in the body does not ? this the code , then if the body have the same alfanumericode it can be fitted safely , you will have only the data frame, etc., of the other vehicle was demolished.
Greetings

[franco-electr]

if you have the texa try to do the replacement, please first read the old and then program the new

[ciccio84]

It is with the Axone says Franco can you do

[franco-electr]

the body computer stralis euro 3 0 5 do not require scodifica as the role to read the code is carried out by other control units immobilizatore euro 3 ,vcm euro5