reading ford focus 1.8 dci delfhi

[alfetta80]

bongiorno at all I should read and maybe even write in the serial a ford focus 1.8 dci delfhi,since I have never made these car I can read and write quietly in the serial, or are there any precautions?type for coding the injectors etc another thing from the schematic I see that a control unit for the engine management and a management injectors,but they are two separate ecu or all integrated in a single??thanks........

[alfetta80]

guys the units are two management engine management diesel injection latter is defective??sirovina usually or not ronbono ever??you can open to check it or is the damage?

[explode82]

I of these cars I don't know how many I've made and all the serial don't have problems usually

[alfetta80]

I of these cars I don't know how many I've made and all the serial don't have problems usually

hello explode I tried to read it with gallov2 clone but nothing other than the law!

[explode82]

you have done the procedure that tells you,serves to activate the mode of reading,you can try the most? time sometimes it happens that they do not open the rel? communication,as you can see when it goes into the communication for reading you have to hear the beeps

[alfetta80]

I do the ecu id and then tells me to turn off the picture you can see the green line that goes very fast, then tells me to turn on the ignition but nothing! or tried a couple of times and then left to lose!

[voglioimparare]

lowers the pull-up and put vel minimum, I recommend that you unplug the fans as they leave for both reading and writing.

[alfetta80]

lowers the pull-up and put vel minimum, I recommend that you unplug the fans as they leave for both reading and writing.
hello!!
that means lowers the pull-up and all speed to the minimum, I'm sorry and thank you!!

guys I have a question, is it possible that by making a mapping incorrect; for example, on the rail pressure, the machine goes into recovery maybe in a week, always in the other, and never is this possible???

[dvdtuning]

usually in parit? conditions, the cio? temperature and "load on the engine", if ? hurt the map should always go into recovery... post the map in question otherwise ? a little difficult to help you.

[alfetta80]

hello dvdtuning,unfortunately, or tried to read it with gallo v2 but I can't I don't know why!!anyway, I think that if it was a problem of the map would always.....

[gezame]

Hello
Many gallo V52 anus problem for this ecu.
Research in the hole to repair your cock.