Scodifica immobilizer alfa 147 1600 petrol bosch me 7.3.1

[danielesgf]

Hello to all. Someone ? managed to delete the partial or total this unit. I tried with car software, but it's not working or something wrong.
Can someone give me some indication?
Thanks

[egs]

You are....I do it with a tool, but on the programs of c'? this control unit, you need to connect to the ecu and then write the file that the program will be based on the cubic capacity...

[danielesgf]

you say you connect directly to the pins out, jumping to the body? I have read that you need to load the file generated by the carsof partial, and after having turned on the picture directly on the car to re-flash with the file ori. Am I wrong??

[ugoboss]

you have to unplug the connectors and make it to the tour, the resets with the file that gives you the program according to your capacity and you're right, I know that on this only the total.

[legendaryslave]

Only total and written in boot mode

[danielesgf]

Hello guys. Nothing to do.I have tried all but nothing to do. In the end I went to a company that repairs power units and after you restore the data in the eeprom( or so but they said) I have scodificata in partial.
Everything works and no spy code on. They told me that for some reason the data in the eeproom had been ruined. Uh excuse me but I am a beginner and so many things I still need to learn.P.s. I know where you were wrong
Thank you for your advice and for the next programming!!

[radd7]

instead, I wanted to know if anyone has mapped this car and what tool he used. thanks

[jolidj]

to map, you always have to read it in the boot, I don't know what tool you have, but if you follow the instructions nn you have problems.
read the ecu and places the file in the right section , someone will help you .

[pititec]

Yes, it reads and writes to safely via the eobd (after you have connected the pin to boot).