Sirius32 s110030304c clio 1.4

[raffaell0]

Good day, I read the flash 29F200BB with a Batronix programmer and gives me the first error( expect a Chip Signaturbytes: 57h 01h =
Read Chip Signaturbytes: C0h 64h ). If l?error know me the law.
Place the file in oroginale bed.
I also edited from address 4000 up to 8000 with FF but not write it. I have also read the doc of sirius32 with ECM but can't find the drivers for this file. There are a lot of clio sirius32, but I do not accept any. A driver with s110030304c can't find it.

[alex68]

test with another programmer, or read with gallo2 on the bench.

[raffaell0]

On the bench I tried that, but 75% of the reading block,being a rooster c*nese.I don't know how to do it.And a flash.If it was na eeprom in 8pin I might do with other tools.But the programmer ? professional.X the fact of the driver, as ever, the nn recognizes? apart from the fact that as the series ecu nn c?? in the list of the ecm that I have.

[raffaell0]

I was able to read it ? as the guide with the ecm in .sie encoded. Pin53 cut, but the car will not start. The led dell immo does not turn on. I also tried with the emulator. L?I edited from address 4000 to 8000 with FF. Post the original file before editing it.

[alex68]

sorry, but the problem is what?? what was it? you have done a scodifica subtotal with the emulator or what? as you scodificato?
we are sure that the problem ? immobiliser=?

[raffaell0]

The scodifica should be total.All?the beginning the problem was that you did read is flash. After having read it, l ?I edited. But since it is a siemens, in reading the discussions you should do a checksum and you must decode *.sie, Right?
The moral of the story ? that I part. If I attach the file that I have written there you can make account if ? the file that was not so good?

[mike99]

It would not have been able to write better flash, before writing should be soppresso.Anche after immo total led dell immo does not turn on .

[raffaell0]

sorry mike but I don't understand what you mean.