Section 1.7 TD

[Marcuc]

Hi all..can any of you tell me how you f? to aumentarela-pressure turbine to the Punto 1.7 TD??? I remember vaguely that you put a T-fitting inserted in the tubes of the wastegate valve, but I don't remember pi? how do you

[legendaryslave]

Hi all..can any of you tell me how you f? to aumentarela-pressure turbine to the Punto 1.7 TD??? I remember vaguely that you put a T-fitting inserted in the tubes of the wastegate valve, but I don't remember pi? how do you

faucet adjustable in such a way as to prevent the complete opening of the bypass valve and see the excess pressure to the inlet of the turbo

[Backgroop]

faucet adjustable in such a way as to prevent the complete opening of the bypass valve and see the excess pressure to the inlet of the turbo

on the point 1.7 td next to the battery c'? the valve overboot under a lid in plastic, connected them with the faucet even if I staccavo simply a tube leaving the turbine is always open

[munro]

backgroop perhaps you are confused with the punto 1.4 gt turbo.....
in many years of workshop, I have never seen any point 1.7 turbo diesel with the valve overboot..***** and you say.....
however, wanting to raise the press turbo point td c'? a third way....
more rough, perhaps, but effective and dismissive...
you raise the car on a bridge and with a lever bends slightly to the bracket for the wastegate....
advise not to go over the 1.2-1.3 bar overpressure....
unless the car in question was not equipped with intercooler....
then the limit not to be exceeded on pain of rotttura of the crowd ? 1.5 bar...

[beppe.c]

I put a valve 1.3-the first of the wastegate without losing so much time,work clean and restorable when you want to.

[motorsport]

Hi all..can any of you tell me how you f? to aumentarela-pressure turbine to the Punto 1.7 TD??? I remember vaguely that you put a T-fitting inserted in the tubes of the wastegate valve, but I don't remember pi? how do you

I also remember you cut the rubber tube and then put the T-piece!!

[lello123]

Even with the tube t increases the pressure only losing the pressure of them, you dirty the engine oil in the long run. I recommend a faucet, also made in house, as well? you can adjust the pressure

[crteam]

the point 1.7 has an overboost the 1.9 jtd.for the change puts the famous and quoted t on the tube westgate then the remaining pipe in the stretch and enter the cicleri that are used for the carburation of the scooter.most large, put it and the more pressure you will have.or a screw valve that you can adjust the air flow that it needs to download.these procedures are the pi? efficient and accurate.I suggest you calibrate with a pressure gauge turbo pressure