Board accessories and equipment for work bench

[eobdexpression]

The people of the forum I thought I'd open this thread just to summarize, via advice, what equipment you have to have to work at a desk in a large way (To get to work safely) premising, that you have to be a good programmer that allows you to work both in serial, but especially in this case, a tour such as bdm jtag tricore etc.
I, for example, I have a rooster v2 v53 that allows me to do that but, besides this, rightly c'? need a lamp for light and a magnifying glass, a template to fix the ecu on which to operate, and then work on it and then what else can? serve in addition to a soldering station? I leave it to you to say what else you would need to start working on it and I think that this might be useful to people who still do not have anything but would like to go in to do this type of work. I hope that it will be useful this split

[sportknight]

let's say that the goal was not seen that there are a lot of threads already? open and special cases, but still just a cock v48 or v53 and a template for the bdm with the schedule,a stabilized power supply, bench and gi? you can do a lot

[motorsport]

quoto..with v53 + mpps etc..can you gi? to work!!

[carlo abarth]

galletto v53 forever!!

[sportknight]

the mpps do not use it more? since I started with the gauls...

[eobdexpression]

Well guys, however if you have any special procedures that are performed with some of the ecu on the bench, and any accessories or material to be used, please write in a way that can be of help to someone else on the forum who does not know, so as to avoid always post multiple identical

[sportknight]

the problem ? that the procedure needs to be case by case,and then the year can be summed up in a post...

[eobdexpression]

For? if each of us put a different experience from the other with a list maybe written, and the model of the ecu would be nice, no?

[Friar]

Stabilized power supply, magnifier with light, gun, hot air and acc to open the ecu and sealant to close them again, maybe a ups, and you could go on for a bit

[marcogti]

Hello to all ? by a p? that I do not write x time problems, I wanted to ask you, but to open the ecu should warming them with a hair dryer to body type and then cut the sealant with a utility knife or c ? another method of pi? safe?

[nox]

Is the hair dryer from the car repair shop is fine but you must not overdo it and then slowly make the lever without inserting too the screwdriver and a little at a time, pull off, however, the eyes not to generalize why? ecu's are not made all in the same way

[Friar]

With a hair dryer from carrazzeria go well, there is no need to cut the sealant is from the se but be careful, do not heat too much in the hand, the excessive heat may harm

[leandro89]

Hello to all ? by a p? that I do not write x time problems, I wanted to ask you, but to open the ecu should warming them with a hair dryer to body type and then cut the sealant with a utility knife or c ? another method of pi? safe?

I think that the phono to the bodywork is the ideal

[eobdexpression]

I would recommend a good station dissaldante