edit kkl cable

[loris_46]

Hello all,I have an elm327 cable that works perfectly(I use it mainly with multiecuscan..)
Now, or even a cable kkl 409.1.I wanted to understand if modified, could I use this for access to the control units,without the use of adapters.
thanks

[admin]

Why complicate your life with these changes then they almost always have problems buying a kit cables and go smooth

[fuorigiri12000]

Would you have a link to a site where you can buy these cables.

[159sportwagon]

Right up to the Admin .there are offers all the cables with 30 euro

[loris_46]

Right up to the Admin .there are offers all the cables with 30 euro
I've seen them this cable to make anything and that the adapters are nothing more than switches that pass the signal of the various channels,with a switch I could with a single cable to do everything that is done with three cables and elm,all over here.but I did not quite clear the connections of the adaptors to be able to do everything.

moreover, the cable kkl I paid 3 euros last year....

[159sportwagon]

On the site of multiecuscan find the plant

[159sportwagon]

Not c'? pi? on the site of the ecoscan. For on the web, you'll find him

[loris_46]

In fact,I tried to see but I can't find anything.now I try gogolando a bit if I find something.

[mincio82]

I latch on to the discussion..I'm using without any problems elm327 interface chinese on my punto mk2b.
The problem arises when I try to connect to the centrina airbarg and power steering.
Using the cable kkl I always get the error latency is too high (and, of course, I am unable to connect)..does anyone know the settings to use in the configuration of the virtual com port?
I'm using windows xp sp3 + multiecuscan 1.1 registered

[159sportwagon]

65916592
Guardian Photos , Are in German language but you understand

[159sportwagon]

In the first photo does not read well . C'? written 30800

In the cable kkl you have to put the latency to 9600 if I'm not mistaken, and elm 30800.

[mincio82]

Unfortunately, I can't see the photos because? I am a user novello, anyway thanks for the response, I try to set the bitrate to 9600.

[loris_46]

Then I missed something ,what? with cable kkl without the changes within in the ecus, airbags and power steering??

[mincio82]

I know it depends on the chinese version of the elm that you have..some need to make a small change, opening it up and making a bridge with resistors between the pins

[jack91]

the solution was found ? xk myself as well as latency is too high