lancia y 1.2 problem can line

[michele30]

I have in the workshop a y with abs warning light on and the message on the display , the system is not available.
I do the diagnosis, and I see 3 units out can the cio? engine steering and abs.
I have already? looked at wires can line ok , I would like to bypass the abs from the can as I exclude?
I thought it was the steering and the "staccato", but then I saw that part from the steering connection to other control units, and then ? for the one that gave me the most? the message.
Do you have any advice?

[159sportwagon]

May be the sensor pair of the steering column . Have you tried to do a proxy alignment

[rts]

But in the other control units there are no errors?? Mail codes

[michele30]

The errors are only in the engine control units, abs, and electric steering.
Now I don't remember well beings but , in the motor can.
In the abs configuration of the country ? this pi? speed? vehicle and can line
in the steering can line it seems to me, and that's it.

[rts]

I had a similar problem and it drove me crazy I had errors in the abs ecu, engine, steering, and body, at the end were the wires that came out of the fuse box that you were broken where they are fastened with clamps to the plug that connects to the box.

[Backgroop]

Could be the sensor, yaw rate under the handbrake lever, which is connected in c-can checked the wiring and the sensor

[enzopezzano]

Same problem on G.Punto, replaced the electric drive and resolved.

[159sportwagon]

Usually when c'? this problem and broke the sensor guide ell. Even if it works well the steering .

[michele30]

the machine ? without esp, and therefore does not have the yaw sensor.
this morning I made the following checks,
I have to say, then message on the display : system not available with abs warning light on and flashing km
if I do allinemanteo proxi I 3 units fuorri , engine, steering, and abs
if stracco the steering tells me that all the units are configured, but since the link ? from the steering wheel that goes to the engine control unit and abs, I understand why? okay.
continuity? wires of the can bus 0/1 then not c'? restistenza.
to check the resistance in ohms, which should be 60 ohms, I try with everything attached?
by the bridge with the multimeter between the can-h and can-l ?

[etkl]

Congratulations, dear friend. Good evening, and good notes.

[explode82]

to me ? 've a similar problem, and it was the body computer that sent the crisis line can

[michele30]

thanks exploder, this morning I did the test with a body even if you do not ? that is exactly the same, but the problem of the message on the display, the more I align all the ecu part of the framework , but since the socket on a machine with exchange dual logic, I guess this is the one.
now I order the body, and we hope that you solve all of them..

[explode82]

nothing, the importnte and that you fixed it....damn body ahahahahha

[leandro89]

Congratulations, dear friend. Good evening, and good notes.

could you explain that?

[Antonio46]

If it can? to be useful I had in the workshop the car for the problem to the body lancia y that create these problems... including flashing km dimming led display alignments that go mad, some go mad when they are in power for the pi? time