I try CITROEN 3 1.4 SID 804 5WS40110E-T

[guidotacco]

I try CITROEN 3 1.4 SID 804 5WS40110E-T because I could not read it with any instrument,all the identify but when I read nothing to do,the tour could go?Or do I have to put it in the boot on the flash
thanks

[cinqueturbo]

s? places some data in the pi? I help you
HW-SW..

[guidotacco]

the file I posted on the request and file the original
thanks

[cinqueturbo]

the file I posted on the request and file the original
thanks

I was going to joke,
anyway...
HW-SW (ID) ECU?

[legendaryslave]

I made it just yesterday, a similar 5WS40068C-T Num HW: 9652888580 Num SW: 9648624280 I tried to read it in the boot but the skema of the rooster not ? correct I found another skema, but standing in the boot not identified, let alone read to the end, I sbroccato, and I have read with the gq4x directly on 29f400, however, once you have done this, and decoded the file can be written from serial for the various tests

[msport (exil77grande)]

exact you have to unsolder and then you can make tests in serial.

[motorsport]

I confirm that it or made one this week, it can be seen from the 29f400 the read with an adapter on the gqx4,dealer and went to the boot on the flasks!!

[guidotacco]

ok,thanks to all,dissaldo the flash!

[legendaryslave]

ok,thanks to all,dissaldo the flash!
also experienced the same thing on a sid 801 only this time I have had to scodificare and I can not write it to the serial in no way gives me error sed key to me that I have to ridissaldare another time

[pinotec]

I have read one in the boot of sid 804 with fgtech
is the schema of fgtech and wrong,
E3 is not to be powered

[cinqueturbo]

I have read one in the boot of sid 804 with fgtech
is the schema of fgtech and wrong,
E3 is not to be powered

This, and the schema of the old v48..
then v53 and wrong?

[legendaryslave]

This, and the schema of the old v48..
then v53 and wrong?
you in the photo ? reported the wrong one E3 but also by detaching does not go into the boot, or at least you didn't go to me

[pinotec]

to put it in the boot ,you used the cable boot (including resistance ) of fgtech?
the adapter to the prota 15pin you removed?

prota=port