removing the eprom glued to the track

[mirks]

Hi guys,
you proceed to remove the eprom, when, besides, of course, welded are also glued to the track?
screwdrivers, thin, box cutters, knives, various?

[guidotacco]

cutter,l important that the tin is melted well,otherwise.....

[maxsek]

sorry, but in what sense is glued to the tracks???you make me an example of the ecu??

[ugoboss]

sorry, but in what sense is glued to the tracks???you make me an example of the ecu??

eeprom edc15 alfa-147-156, they have a drop of glue under and you have to be careful that you can break.

[maxsek]

OK...I've never seen the problem even why? dissaldo hot air and of course the glue gives way...

[sa80libero]

when you use the hot air over the pond also melts the glue...

[guidotacco]

when you use the hot air over the pond also melts the glue...
not always!

[etkl]

Test trichloroethylene, but be careful because? ? to be very toxic.

[LL205gti]

trichloroethylene, called commercially as well as over that toxic ? rather aggressive on the plastic, so watch out!

[alex68]

OK...I've never seen the problem even why? dissaldo hot air and of course the glue gives way...
it is very good I also do so

[legendaryslave]

slightly with a knife and tin hot, and the most unpleasant are those of the air bag with that sort of silicone

[etkl]

Absolutely toxic, true, cos? the attention ? pi? aggressive to the copper and plastic in my opinion.

[carlo abarth]

usually with hot air gives way and I never had any of these problems ..!!!!

[mirks]

I also use hot air, but the other day I was unsoldering the 24c16 a bosch a daily,
nothing to do, began to sbricciolarsi, at that point I went decided but you ? route, luckily I had already? the file I fixed that with a new...