Clone Mercedes EZS

[ecutano]

Raga hello , I want to replace a block which start. EZS Mercedes , I had read time f? a thread where you described how to clone the EZS , do you have any info .
Thanks

[dvdtuning]

Watch there I was working on it, but I abandoned the work because? I have found very little info around...

[legendaryslave]

you have to move the two processors ? an operation is a bit difficult, but doable

[ecutano]

you have to move the two processors ? an operation is a bit difficult, but doable

Hello , the processors are the two Motorola ZC410730CFU ?, you have already? tried it and it works ?, but then there is also the radio remote control for opening doors ?
Greetings

[legendaryslave]

Hello , the processors are the two Motorola ZC410730CFU ?, you have already? tried it and it works ?, but then there is also the radio remote control for opening doors ?
Greetings
you've already executed the work with success I unsoldered and resolder the two processors on the block new eye, though, that often the problem ? the key for the wireless remote control, you have to use the original bdella car

[tecnoecu]

hello if you want to avoid unsolder the processor around you can find some programmer can riutilizzarti the key block that you have taken in the demolition.

[ecutano]

you've already executed the work with success I unsoldered and resolder the two processors on the block new eye, though, that often the problem ? the key for the wireless remote control, you have to use the original bdella car
Done , everything is OK , run the original keys of the vehicle and also the remote control is ok , Thanks

[motorsport]

you've already executed the work with success I unsoldered and resolder the two processors on the block new eye, though, that often the problem ? the key for the wireless remote control, you have to use the original bdella car
I confirm that I and a feasible task, but a little mangy!!

[isfedale82]

hello if you want to avoid unsolder the processor around you can find some programmer can riutilizzarti the key block that you have taken in the demolition.

hello ? can know some information about these programmers without removing the processors, thanks

[isfedale82]

I confirm that I and a feasible task, but a little mangy!!

do you know any tool or program to edit and read the eprom?

[guidotacco]

do you know any tool or program to edit and read the eprom?

rosfar r270,it reads the eeprom and flash on board..

[isfedale82]

rosfar r270,it reads the eeprom and flash on board..

then you need a program to change the reading?
do you know if avdi reads the eeprom and flash from the obd?

[guidotacco]

then you need a program to change the reading?
do you know if avdi reads the eeprom and flash from the obd?

in this case, you only have to clone then what you read on the old write on the new,instead if you have to do the miles, or new keys etc... there are special programs

[isfedale82]

in this case, you only have to clone then what you read on the old write on the new,instead if you have to do the miles, or new keys etc... there are special programs

do you know the names of these programs?
does anyone know if with avdi, you can clone or change the flash directly from the obd?