program willem

[cjack]

does anyone have the program for the willem pcb5?
I downloaded the official one from the site but it seems to have all the eprom...
for example, does not have the Macronix MX25L512 that for? should do...

[alfajtd]

I checked on my sw that use pcb50a 098d12

you have to go to SPI flash 25xxx
MxIC
and selections MX25L512

[cjack]

I downloaded that version of the program... Now I see the chip:) thanks

[alfajtd]

well let me know....
;)

[fabioefra44]

Someone knows how to configure it? After I installed the program and set by the bios the parallel port as bidirectional,the pc I find the programmer, but I read the flash but it is empty once the file is open . By what is pu? depend? I look forward to

[fabioefra44]

No pious soul?

[Four]

am I in trouble?, as I have a pcb45 inherited and I can not read the plcc32..., we would like a nice guide, maybe in Italian. The problem is that until now it has me date anyone...hope that someone help us!

[cjack]

am I in trouble?, as I have a pcb45 inherited and I can not read the plcc32..., we would like a nice guide, maybe in Italian. The problem is that until now it has me date anyone...hope that someone help us!

if you search on google you will find a few rough guide, I found some at the time ( I have more)....
if it does not read the chip tries to use the 12-volt power instead of the usb... I had this problem and I solved...
of course, when you change the power you need to move the swich...

[fabioefra44]

Thanks,will try? in this way, and place the result

[pinotec]

I with the willem I couldn't read the 95xxx, I also read an empty file ,in the end the problem was that it was wrong to set the jumper of the vpp a18
that on the schema of the settings ..the ed, on the contrary

[fabioefra44]

But the scheme you find on the desktop when you select the hardware to be read,or am I wrong?
Your had the three leds or only 2?

[pinotec]

-the settings you see when you select the chip concerned
-3 led