MPPS v12 on MB C200 115hp W203

[V.V.]

The first problem with MPPS v12 box version of the forum and MB W203 C200 115hp 2002.

The situation ? this (I took risks whereas the car ? throw it away):

ID ECU with the protocol EDC15C6 - does Not work!
Read on EDC15C6 - does Not work!
Write ORI with the same protocol - it Works!!!

Why does not the law but the writes? I have used the CTEK MXS10 and the voltage was 13.8 v, not c'? was to read it, even trying different protocols, depends on what?

[leandro89]

probably, this ecu can you? just write

[blackwolf76]

The ecu, in part, that when you write puts the fan motor to the maximum, it reads very easily with any instrument. I have read and written with gall 1260, mpps v5 and gallo v2 in all the sauces.

Ergo I know that I can or wrong protocol or you have the tool with a problem...

[V.V.]

Perhaps found the arcane, uninstalled, MPPS v12, and installed again, I tinkered a bit too much with the OS *_*!!!

[msport (exil77grande)]

Perhaps found the arcane, uninstalled, MPPS v12, and installed again, I tinkered a bit too much with the OS *_*!!!

I knew that, as usual, you say everything is ok, everything here, all of them, and at the end or the pc is messed up or smanettate.

[V.V.]

Messed up that you can't? say, can I say otherwise that my OS are very clean and well optimized (both ****s list services, the registry, even if I have to say that the methodology of the development of the OS M$ not me ? never liked it) :), update some of the system DLL to me it was necessary for the operation of other tools in me needed for the reprogramming of some of the EEPROM intended for PC motherboards and VGA, that's all! That said, the MPPS of the Forum works ? a bomb, I could not be pi? happy, I was just trying help why? I didn't think to go to rage on the operation of the interface with this :)!

P.s
I was wondering if it was possible to use an interface of this kind on any Gnu/Linux distribution, has someone tried it?