Already
07-08-2013, 22:37
Hi
Mpps v5 tested and stratestato on edc16c39 working perfectly.
I have to close an egr on this car (147 1.9 jtdm 120cv 2007) already mapped. I read the file. I close The egr using ecm titanium. Titanium I do not recognize the file, and then does not find the driver, because it was a mod file. I think that mpps automatically corrects the check and go forward. I write and when it gets to 100% instead of giving me the closing of the framework I d? error.
Without closing the framework, rewrite the file that I had read and all v? to a good end.
Ritento for? this time I try file ori and do I fix the check to the program the ecm, but to write the same problem. Ex-mpps and attack the gallov2 I select the driver, and the well-known 2 strange things. By id the ecu told me that the driver was wrong and the number of hw and sw of the id ecu were identical, and obviously you start writing. Rewrite the file read with mpps and all goes well.
I reread the file directly with gallo v2 (id ecu and driver recognizes them perfectly) I prepare it through titanium and I always via gallo v2 and everything works correctly.
Where is the catch?
Mpps v5 tested and stratestato on edc16c39 working perfectly.
I have to close an egr on this car (147 1.9 jtdm 120cv 2007) already mapped. I read the file. I close The egr using ecm titanium. Titanium I do not recognize the file, and then does not find the driver, because it was a mod file. I think that mpps automatically corrects the check and go forward. I write and when it gets to 100% instead of giving me the closing of the framework I d? error.
Without closing the framework, rewrite the file that I had read and all v? to a good end.
Ritento for? this time I try file ori and do I fix the check to the program the ecm, but to write the same problem. Ex-mpps and attack the gallov2 I select the driver, and the well-known 2 strange things. By id the ecu told me that the driver was wrong and the number of hw and sw of the id ecu were identical, and obviously you start writing. Rewrite the file read with mpps and all goes well.
I reread the file directly with gallo v2 (id ecu and driver recognizes them perfectly) I prepare it through titanium and I always via gallo v2 and everything works correctly.
Where is the catch?