Scodifica total bosch M 1.5.5 0 261 204 948

[special]

a greeting to all the members.. I should scodificare a control unit outlet demolition of an alfa 156 1.8 ts year 99
code bosch 0 261 204 948
family unit: bosch m 1.5.5

tests run: 1? trial serial mpps I tried to upload the file here on the forum for the scodifica total, which is connected to the ecu on the car and powered the pin 10 and checked that the voltage is higher than 13v attempting to load the file from the error probably why? the control unit having been recovered in the demolition does not read the key code is not allowing the writing.
2? test: I was able to write the file scodifica for serial writing ? took place on the bench in boot mode with fgtech but without result.


I wonder if there is a file to load the boot mode for the scodifica total or other solutions.

[legendaryslave]

Have you written to the file that generates the carsoft writing with the cock, and andataa good end

[special]

the gallo marks write 100%

[legendaryslave]

try with this do know, of course, off the box code

[special]

first of all thanks a lot really nice.. a question to load this file I have to upload it to the tour putting into boot mode ? write with fgtech or another serial right?

[legendaryslave]

In the serial-to-tour-with fgtec2 in bootmode

[special]

then loaded with galletto 1260 in boot mode and the car starts quietly but in diagnosis that by making the reading of the data with the cock to me by a bosch code which turns out to be a GTV 2.0 TS while the car in question, and a 156 1.8 ts 1999
a question, but this file ? was created with carsoft? if you give me a tip I could process the original file of the 156 1.8 ts
thanks again for your interest

[alexracing]

hello special I've tried to read the tour a bosch 1.5.5, but without results ,I use rooster v50,the cock,mpps,I could send you the pin out that you have used and also the procedure thanks in advance.

[special]

hello special I've tried to read the tour a bosch 1.5.5, but without results ,I use rooster v50,the cock,mpps,I could send you the pin out that you have used and also the procedure thanks in advance.

hello this is not for you to read, write only

[alexracing]

you I was wrong I wanted to say write it
I already have the file but I can not write it

[special]

6119

this ? the pinout and the point to put in boot mode the ecu

[alexracing]

unfortunately I do not have the permission to download the file but thanks also for the collaboration,if it is difficult you can please print please thanks

[SGHERRY]

hello,there is not a single procedure x the tot. the first thing we want to the kwp,then there are 2 files to write, and as you type, the first at a precise point comes off the imm. the operation should be done on the car and the centr. in the boot...

[mirks]

can you explain step by step?
I believed enough caricargli to tour in the boot file and via

[alexracing]

using the suitable equipment without problems,I after several tests I bought the encode of elettronicauto and the council for the ease and the wide range of power units that can do

[mirks]

you will be also with the cdc, you do it quietly, and taking a clone it is very little, it was only to help those who do not have special equipment.

[alexracing]

An economic tool to write this ecu and kv2000 for the file, can you rely on carsoft