opinion the map

[max75]

Hi to all this ? my first map I accept your advice and opinions ...thanks in advance.

[SandroMarciano]

I do not like it, times changed without exploiting even the ones that are unused by ori, table pair/IQ changed without the policy (? can also give the error)...

Given that you have the most? 80 messages, I would advise trying hard some map similar engine already? ready and read all the reasons for which a given map goes mod in a way instead? in another. For your engine to c'? written all over the forum...

[max75]

thanks Sandro for the attention that I devote to the table torque/IQ mean quantity of fuel.... right?for the injection times I have given the same torque request, for the rest, what do you think....

[max75]

so I coreggo if I understand correctly, to change the IQ you have to see the minimum value ? the maximum obtained in the required torque ? go to change in that area by bringing the same increments....in miko's case, the min value ? 194 ? the max 425...***** and logic there are !!!!

[SandroMarciano]

no, the incementi should not be connected... you get up in the pair, then the ecu increases the fuel (up to a certain limit).
Not you have to start out from the idea of giving a 20% to 10 from one another. knowing the diesel fuel that the ecu injects ori fixed a goal and adapting all the maps in such a way that it reaches you, otherwise you don't control the change...

[max75]

Ok tomorrow I will try to strive to put into a little .....soon

[max75]

So I should set a goal, but I need to know up to what point can I increase ... right

[SandroMarciano]

you, ? correct, but if you see in the discussions of engines similar to yours, there are good examples, with the limits for a reliable map and a little less...